PreForm recommends a default height value of 5 mm. If it’s too low it may cause support deformation of failure. The disadvantage of the preform method is that only a finite length of the preform is made each time, which means that a limited amount of. It can be lowered to reduce the resin usage but it can’t go lower than 2 mm. The preform method allows us to manufacture a variety of POFs, for example, single mode and multimode fiber, twin-core fiber, dye-doped fiber, inorganic-doped fiber (e.g., erbium), and electrooptic fiber. Support structures improve print reliability and can be generated automatically from within PreForm or added manually. The purpose of supports is to prop up overhangs, spans, and other unsupported minima to ensure a successful print. L'installazione di PreForm include anche la versione più recente del firmware delle nostre stampanti, che puoi aggiornare in qualsiasi momento.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |